DDUDHPRD Operation Manual SL1577 Digitally Controlled Split Split Lid Lid Toaster PROPROCESS CORPORATION P.O. Box 869 O 7328 Madison St. O Paramount, CA 90723 (562) 531-0305 O (800) 624-6717 O Fax (562) 869-7715 DDUDHPRD Website:www.doughpro.com www.doughpro.com E-Mail: info©doughpro.com Website: PDF compression, OCR, web optimization using a watermarked evaluation copy of CVISIONinfo@doughpro.
Operation Instructions Step 1 Step 2 Carefully unpack and clean grill plates with mild soap then sponge clean with cold water. Place in location where it will be used allowing for clearances per the dimensions indicated. WARNING O ALLOW 2” MINIMUM CLEARANCE between adjacent equipment and/or wall areas. O DO NOT touch hot surfaces. Step 3 Plug into proper 3 prong wall outlet. If other appliances are connected to the same circuit make sure the total load does not exceed maximum ampacity of the circuit.
DDUDHPRD SL 1577 Operating Operating Instructions: Instructions: SL1577 1. 1. Press desired desired time time to start the time cycle. After the cycle is finished, Press finished, press it again to reset the time cycle. Digital Time Digital Display Temperature Controls Clean Cycle 275 o 0271 1.5.lS.4tW.E:1J.1: ATTENTION: To maintain maintain proper temperature To settings close lid lid when when not not in in use. use.
DDUDHPRD Instruction’s for Adjusting Adjusting the the Temperature Temperature Instruction's for PRESS and hold the TEMP and ARROW up buttons simultaneously simultaneously for 5 seconds. buttons The current temperature setting will display on the right digital display only. Using the ARROW buttons, you may now adjust the temperature to your desired setting. setting. Once you have set your your desired desired temperature temperature simply simply push push the TEMP button.
72 7 73 2 14 6 7 7 46 A3 5 19 16 3 18 4 16 17 16 15 13 71 12 1 69 8 9 SL1577 PDF compression, OCR, web optimization using a watermarked evaluation copy of CVISION PDFCompressor 10-31-08
36 35 23 26 37 34 27 28 38 67 40 29 41 29 38 6 31 41 39 37 63 38 25 59 27 28 33 67 24 1 30 31 29 5 22 32 21 29 A1 29 5 22 25 A2 33 20 PDF compression, OCR, web optimization using a watermarked evaluation copy of CVISION PDFCompressor SL1577 10-31-08
64 59 61 60 64 62 A4 53 56 57 52 25 25 57 56 60 A5 68 59 69 65 16 55 54 67 58 1 69 51 58 54 50 67 49 68 48 47 16 45 66 23 16 42 44 SL1577 PDF compression, OCR, web optimization using a watermarked evaluation copy of CVISION PDFCompressor 10-31-08
SL1577 ITEM # 1 2 3 4 5 6 7 8 9 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 DESCRIPTION MODEL SL1577 LOWER WRAP AROUND SHROUD ASSEMBLY LOWER PLATEN LOWER PLATEN INSULATION COVER, LOWER PLATEN ASSEMBLY SET SCREW 3/8-16 x ½ SCREW SET STAINLESS STEEL 3/8-16 x 1-1/4 GREEN INSULATION WASHER HEX NUT 3/8-16 STRAIN FELIEF FUSE HOLDER 1 AMP FUSE BUSS 1 AMP PIN, BACK STOP RELAY SCREW, PHILI. PAN HEAD 8-32 x 3/8 S.S.
SL1577 60 61 62 63 64 65 66 67 68 69 71 WASHER 5/16 FLAT, 5/16 I.D. X .680 O.D. SHROUD, LEFT ASSEMBLY SHROUD, RIGHT ASSEMBLY SET SCREW 3/8-16 x ½ SCREW, SLOTTED PAN HEAD 10-24 x 5/8 STAINLESS STEEL BACK COVER POWER CORD WASHER FLAT 3/8 x .050 THICK SHOULDER BOLT, SHOULDER Ø3/8 x 3/8 LG,THREAD 5/16-18 x ½ LG WASHER FLAT 3/8 x .085 THICK PHILLIP SCREW 2-56 x ¼ 72 SCREW BOLT HEX HEAD 1/4-20 x 1.
SL 1577features: features: SL1577 Deflecting guard. Deflecting guard. Cleaning debris drop. Spatula holding slot. slot. Debris tray Deflecting shield. Deflecting shield. New leveling leveling system! New Ensures even even grilling! grilling! Easy access access panel: Easy Simply remove six screws on each side of the rear rear panel. Pull up the rear panel with both hands. hands. ALL components are exposed exposed for easy easy & fast fast access. access.
PLEASE READ CAREFULLY BEFORE ATTEMPTING TO USE THIS APPLIANCE. LIMITED MACHINE WARRANTY WHAT IS COVERED Proprocess/Doughpro warrants the SL1577, from manufacturing defects in workmanship and material sold within the domestic United States. HOW LONG DOES THE COVERAGE LAST One-year warranty for parts and labor. The heating elements on the upper and lower platens have a limited lifetime warranty on the elements.
DDUGHPRD STEARNS PRODUCT DEVELO PMENT CORPORATION 20281 Harvill Ave, Perris, CA 92570 Tel: (800) 6246717 - Fax: (951) 657-4594 Warranty & Return Policy STEARNS PRODUCT DEVELOPMENT CORPORATION warrants ai products nanufactured by it ainst defects in workmanship or materidis from the Jate of pLrchase far a period of (1) year on parts and obor, This warranty app'ies to only equipment purchased and used in the United States. Exclusions: i .
