Use and Care Manual

Removing & Replacing HEPA Dust Bag

Important: For best performance DO NOT use the vacuum without all filters, cloth dust bag, or

without the HEPA dust bag in place.

1. To remove the HEPA dust bag, press on the canister lid latches on each side of the unit to unlock

(Fig 1) and lift the canister lid. The dust bag will come out when the lid is removed

2. Pull the tab on the HEPA dust bag holder out slightly and lift upwards. (Fig. 2)

3. Holding the HEPA dust bag top in your hand, slide it out from the slots in the bag

holder. Hold carefully to avoid having dust falling out of the HEPA dust bag.

4. Replace the HEPA dust bag with a new bag by inserting the cardboard bag top into the bag holder

and slide it in. Do not reuse the same vacuum bag.

5. The cardboard face of the new bag should rest securely in the dust bag cover guides. Flip the bag

holder over and press the tab until it clicks, locking the bag into place.

6. Cleaning the cloth shake out bag is recommended at this time.Once cleaned, place the cleaned

cloth dust bag into the vacuum.

7. Insert the HEPA bag back into the vacuum and replace the canister lid locking it into place by

latching the lid clips back down.

NOTE: Never overfill the HEPA Dust bag – replace when bag is full and clean the cloth dust bag

and filter each time the HEPA dust bag is replaced.