Use and Care Manual

ATTACHING THE FLEXIBLE HOSE & TELESCOPIC WAND TO

THE VACUUM

NOTE: The flexible hose should be connected before strapping the unit on.

1. To connect the flexible hose to the unit, slide the hose connector into the air inlet (Fig 1).

2. To connect the flexible hose to the telescopic wand, slide the attachment end of the hose

connection over the upper end of the telescopic wand (Fig 2).

3. To adjust the wand, locate the black clamp and pull up on the release lever to release tension

from the clamp. Once tension has been released, you can adjust the wand to desired length. If

the wand still does not move, locate and loosen the small set screw on the opposite side of

the lever. (Fig 3)

4. Plug the power cord into the electric outlet.

5. To remove the flexible hose, unplug the power cord and pull the hose connector from the air

inlet.

6. Pull the handle out from the telescopic wand (Fig 3).

Fig 1