Use and Care Manual

20
4.
Grab the HEPA filter inside the filter cover and pull the filter out.
5.
The filter can be cleaned by tapping it over a garbage can or other receptacle. A can of compressed air is
also a great way to clean the filter.
6. Any built up dust on the filter cover can be wiped off or blown off with compressed air.
7. Insert the cleaned HEPA filter back into the filter cover and insert the filter cover back into the dirt bin.
8. Twist the filter cover clockwise locking it into place and close the bottom cover lid.
9. Reinstall the dirt bin onto the vacuum unit. The vacuum is now ready to use.
Note: If deep cleaning is needed for the HEPA filter and filter cover these parts can be soaked in warm, soapy water,
cleaned with a cleaning brush, and rinsed off with clean water. Let these parts air dry completely for at least 24hrs
before reinstalling both parts.
Note: Make sure the filter and filter cover are properly assembled and locked in place before use. NEVER use the
vacuum without filters.