Use and Care Manual

14
Hair Clipper
Note: Do not touch the blade if the guide guard is not installed.
Note: Please be careful on the soft parts of the pet's skin and do not use excessive force which
can cause scratches to the skin.
Note: Clipper attachment will require (2) AA batteries which are sold separately.
1. Attach the clipper attachment to the hose end and select which guide guard is
preferred. We would recommend starting with a longer guide option and testing the
length. If a shorter length is desired replace it with a shorter guard until the desired
length has been reached. Review guide guard
replacement section.
2. Once the attachment is connected and the proper
guide guard has been selected you can then turn
on the vacuum and select the correct speed. For
trimming you’ll want to use Eco Mode.
3. Turn on the clippers by flipping the switch on
the clippers to ON and begin clipping your pet’s
hair while also keeping an eye on the amount of
hair in the dirt bin and listening for any changes
to the sound of the vacuum motor. A higher
pitched sound, or loss of suction, can mean a
clog has built up. If this happens review the
maintenance section.
Comb and Guide Guard Replacement
To change the comb attachment:
1. Unlock comb if locked by sliding the comb lock button sideways.
2. Once unlocked hold the de-shedder attachment so the
comb is facing you and grab the comb attachment
between your fingers.
3. Push the comb attachment to the right so it’s pressed
against the yellow panel on the side of the de-shedder
attachment.