Use and Care Manual

- 12 -
4. Wipe the area clean with a clean cloth or use the included microfiber cloth pad.
n HOW TO CLEAN SCRUBBING PADS
There are multiple sets of cleaning pads that are included with your buffer, when they become dirty, you can
simply take them off the buffer, and wash them by hand in your sink with warm water and a mild detergent for
lightly soiled pads, or in your washing machine on a light duty cycle with mild detergent for heavily soiled pads,
and allow to air dry. DO NOT PLACE IN THE DRYER.
n CLEANING THE HOUSING
WARNING: Always switch off the appliance and disconnect it from the outlet before cleaning it.
ATTENTION: Do not use Alcohol, cleaning or scouring agents to clean your machine, as these may damage the
appliance. Clean the outside of the housing using only a slightly damp washcloth.
Troubleshooting
WARNING: Never use a defective appliance. Always switch off the appliance and disconnect it from the outlet or
remove the battery before you start to troubleshoot.
Fault
Possible Cause(s)
Solution
The unit will not turn on.
The battery is not charged.
Make sure the battery is fully
charged by plugging the battery
charger into the charging port, then
plug the charger into your wall
outlet and keep the charger plugged
into the unit until the charger light
turns Green. (See pages 6 - 10)
The battery is not connected into
the unit properly.
Make sure the battery is plugged
into the cleaner, making sure the
wire connection form the battery to
the cleaner is properly seated. (See
pages 6 – 10)
Switch is in the “off” position.
Turn the on/off switch to the On
position. (See page 6).
The brush speed is low.
The battery is not fully charged.
Make sure the battery is fully
charged by plugging the battery
charger into the charging port, then
plug the charger into your wall
outlet and keep the charger plugged
into the unit until the charger light
turns Green. (See pages 6 - 10)
The spinning brushes are dirty or
debris is trapped in or around the
brushes.
Remove the debris that is causing
the slow brush speed, and clean the
buffing pads If necessary. (See
page 11-12)