Use and Care Manual

Function

switch

intr

oduction

1. 2. 3. 4. 5.

1. Air Quality Sensor: Blue = Good, Red = Bad

2. On/Off Switch

3. Anion Switch

4. Fan Speed

5. Timer

1. Air quality- particulate sensor device is installed in the Air Purifier. During the first 3

minutes of starting up the unit, the air quality indicator light ﬂashes red and blue

alternately. After 3 minutes, if the air quality is good, air quality indicator light is blue.

If the air quality is detected to be bad or getting worse, the air quality indicator is red. If

the air quality is medium (between clean and dirty), the indicator light shows purple.

When the unit is in automatic mode, this machine adjusts according to the air quality,

adjusting the air volume of the machine automatically, to be truly intelligent.

Note:

①Because the smell sensor is based on the air cleanliness when power plug is inserted,

it’s suggested to insert the plug (the benchmark of smell sensor varies according to

indoor air cleanliness automatically) when the indoor air is clean (for example, no

smoke smell).

②If the Air Puriﬁer is put in the room with contaminated air quality, the indicator of Air

Puriﬁer may show error until air is clean (for the correct way please refer to ①).

2. Turn ON/OFF machine -After unit is connected with main power supply, buzzer

makes two harmonious tones with two ﬂashing lights and the machine is in power-up

mode.

Press ON/OFF button and enter into automatic mode, the buzzer makes three

harmonious tones and ON/OFF indicator light is on, displaying in red. The machine will

automatically purify the air according to the air quality. When air quality indicator light is

blue, the machine will adopt a low speed gear to purify air. When air quality indicator

light is red, the machine will adopt a high speed gear to purify air.