Use and Care Manual
- 13 -
Clean and replace the exhaust HEPA filter
1. Open the exhaust cover by rotating in count clockwise. (Fig 13)
2. Put the exhaust HEPA out of the unit. (Fig 13)
3. Clean the filter, using warm water and allow air-drying completely, and then assembling the filter back into the
unit. Or, if the filter is too dirty or in an unusable condition, replace the filter with a new one.
Fig 13
Cleaning the Housing
WARNING: Always switch off the appliance and disconnect it from the outlet before cleaning it. See section "Switching
Off and Retracting Power Cord.”
ATTENTION: Do not use Alcohol, cleaning or scouring agents to clean your machine, as these may damage the
appliance. Clean the outside of the housing using only a slightly damp washcloth.