Use and Care Manual
- 12 -
Fig 9
" HOW TO EMPTY THE DUST CONTAINER
You will want to empty the dirt in the dust container as soon as it has reached the “MAX” mark indicated on the
outside of the tank, or if the suction power has dropped. To empty the Dust Container, please follow the
instructions below.
1. Switch the vacuum cleaner to the “Off” position and disconnect the plug from the wall outlet.
2. Release the dust container by pressing down the release button. (Fig 10)
3. Pull the dust container away from the vacuum cleaner.
4. Hold the dust container low over your trash receptacle, to avoid dust falling onto your floors.
5. Then press the release button. When the release button is pressed, the bottom cover will open and the dust
will drop into your trash receptacle. (Fig 11)
Fig 10 Fig 11
" HOW TO CLEAN AND REPLACE THE HEPA FILTER(s)
There are two filters in this unit, when the Filters are dirty and the suction power is reduced, you must clean or
replace the HEPA filter.
Clean and replace the Air Inlet filter
1. Open the dust container cover by rotating the cover counterclockwise. (Fig 12)
2. Pull the top inlet HEPA filter from the container by rotating it counterclockwise to unlock it, and then pull it up
and out of the unit. (Fig 12)
3. Clean the filter by gently knocking it against an object. For deeper cleaning you may also use warm water,
then allow the filter to air dry completely. Once the filter has completely air dried, then assemble the filter back
into the container. Or, if the filter is too dirty or in an unusable condition, replace the filter with a new one.