Use and Care Manual
- 10 -
Fig 3 Fig 4 Fig 5 Fig 6
" Connecting the attachments to your wand
To connect the tools to your attachment wand, you will loosen the ring on the end of the
attachment wand by twisting it counter clockwise. (Do not loosen the ring all the way; you
only need to loosen it enough for the tool to slid in) Then insert the tool you would like to use
and tighten the ring clockwise on the attachment wand to lock the tool into place. (Fig 7)
NOTE: The Crevice tool, Duster brush, and Upholstery Tool are most commonly used by inserting them into the
end of the rubber hose. The only time they need connected to the wands is to reach a higher area.
Proper Vacuuming Technique With The Prolux 2.0 Floor Tool
When vacuuming with your Prolux 2.0, you may vacuum using the standard forward and
backwards vacuuming motion as you would with standard vacuum cleaners. However because of
the new Prolux 2.0 floor tool design, you can vacuum an area by vacuuming in half circle motions
and vacuum the same area 2x as fast.
• Start with holding the wand as seen in (Fig A).