Use and Care Manual

4.4 Changing the motor
protection filter
1. Switch off the vacuum cleaner and remove the dust filter
bag as described in Chapter 4.1, "Changing the dust
filter bag", steps 1 thru 4.
2. Remove the filter holder with motor protection filter
(Fig. 22/1). Your first flip the filter holder forwards and
then pull the filter up and out.
3. Remove the motor protection filter (Fig. 23/1) from the
filter holder (Fig. 23/2) over a dustbin.
4. Clean the filter holder.
5. If the new motor protection filter is too large, lay the the
old filter onto the new filter mat. Mark the contours and
cut the new filter down to size with a pair of scissors.
6. Insert the new motor protection filter into the filter
holder.
7. Insert the filter holder with the new filter into its bracket
from above and push it down until it audibly locks into
place.
8. Replace the dust filter bag and close the dust
compartment cover. The cover clicks into place audibly.
4.5 Cleaning the housing
Clean the outside of the housing using a slightly damp cloth only.
WARNING:
Always switch off the appliance and disconnect it from
the electrical outlet before cleaning it Chapter 3.3, "Switching off
and retracting power cord.”
ATTENTION:
Do not use cleaning or scouring agents or alcohol, as
these might damage the appliance.
5 Troubleshooting
Before sending the appliance to the Prolux authorized service center, check if you might be able
to correct the malfunction yourself following the list below:
WARNING:
Never use a defective appliance. Always switch off the appliance and disconnect it from the mains
before starting troubleshooting Chapter 3.3, "Switching off and retracting power cord.”