Use and Care Manual

1.5 Re: Mains connection
The appliance runs on electricity, which means there is always danger of electric shock. So please especially
observe the following:
- Never touch the plug with wet hands.
- Always pull directly at the plug if you want to disconnect the appliance from the mains. Never pull the mains lead as it
might break.
- Take care that the power cord is not bent, pinched, rolled over or comes in contact with heat sources.
- Use only extension cords suited to the power requirements of the appliance.
- Never immerse the appliance in water or other liquids.
- Only operate the appliance if your mains voltage is the same as that indicated on the appliance's name plate. Wrong
voltage can destroy the appliance.
- If the power cord of this appliance is damaged it must be replaced by authorized service representative or a similarly
qualified person to avoid danger to the user.
1.6 If the appliance is defective
Never use a defective appliance or operate an
appliance with a defective power cord. There is a major risk
of injury.
Refer a defective appliance to an authorized dealer or
the RoyalAppliance service for repair. Address: Page
35, "Warranty.”
2 Unpacking and assembling
2.1 Unpacking 1. Unpack the appliance and all its accessories.
2. Check that the contents are complete. Information regarding scope of delivery !"#$ 20, "Overview of
your M7000.”
ATTENTION:
Always transport or ship the appliance in its original
packaging to avoid damage. Keep the packaging for
such an event.
Dispose of no longer needed packaging material
according to the applicable regulations of your country.
NOTE:
Immediately contact your dealer if you have found
damage resulting from transportation.
2.2 Assembly
1. Insert the end of the suction hose (Fig. 2/1) in the intake
opening (Fig. 2/2), then into the intake opening of the vacuum
cleaner, until it locks with an audible click.
2. Insert the handle (Fig. 3/1) into the upper end of the
telescopic tube (Fig. 3/2).
3. Attach the floor nozzle (Fig. 3/3) to the bottom end of
the telescopic tube (Fig. 3/4).
4. If you are vacuuming carpet instead of the floor nozzle,
you will want to attach the electric power nozzle to the wand
by snapping it into place.
5. Adjust the length of the telescopic tube. Press the
release latch on the tube down (Fig. 4/1). Then pull
the handle of the telescopic tube to extend it to your desired
length (Fig. 3/1). Let go of the release catch while
pulling until it locks in place. You will hear a distinct
click.