Owners Manual Prolux Stealth Owners Manual We Know Vacuums!
Index 1 Safety notes............................................................................... 22 1.1 Re: Operating Manual ................................................................................................. 22 1.2 Re: The Notices Given ................................................................................................ 22 1.3 Re: Children................................................................................................................. 22 1.
Tools – Easy to use, on board tools for nearly every job. 1 Safety notes 1.1 Re: Operating Manual Read this operating manual carefully before using the appliance. Keep the operating manual for reference. Include the operating manual if you pass the appliance to third parties. Violations of the operating instructions can lead to severe injuries as well as damages to the appliance. Prolux takes no responsibility for damages due to violations of these operating instructions. 1.
1.5 Re: Mains connection The appliance runs on electricity, which means there is always danger of electric shock. So please especially observe the following: - Never touch the plug with wet hands. - Always pull directly at the plug if you want to disconnect the appliance from the mains. Never pull the mains lead as it might break. - Take care that the power cord is not bent, pinched, rolled over or comes in contact with heat sources.
Your vacuum cleaner is now ready for use. WARNING: Only assemble the appliance if it is not connected to the electrical outlet. The appliance could be switched on by accident. NOTE: It might be necessary to push a bit harder as needed. 2 Unpacking and assembling 2.3 Using further nozzles (accessories) Besides the floor nozzle you just attached, you may extend the functions of your vacuum cleaner with other attachments.
3 Operation 3.1 Vacuum cleaning . 1. Attach the desired nozzle or pull out the Chapter 2.2, "Assembly" power Chapter 2.3, "Using further nozzles (accessories).” 2. Pull the cord until the yellow marking is visible (Fig. 10/1). 3. Switch on the vacuum cleaner with the on/off switch (Fig. 11/1). WARNING: Check the vacuum cleaner and the power cord each time before using it. A damaged appliance must not be used. There is danger of injury.
increases suction power. The - button (Fig. 14/3) reduces suction power NOTE: With the bypass vent (Fig. 13/1) you can quickly reduce the suction power if less power is needed, or to release objects accidentally sucked in. 3.3 Switching off and retracting power cord 1. Switch off the vacuum cleaner with the on/off switch (Fig. 15/1) and pull the plug from the mains socket. 2. Keep the plug in your hand. 3. To retract the power cord, push the cord retracting button (Fig. 15/2).
retracting power cord.” In this way you avoid dust destroying the appliance. NOTE: Be careful when removing the dust filter bag so that no dust escapes. NOTE: You can dispose of the dust filter bag with your regular domestic trash if it contains no prohibited waste materials. NOTE: The dust compartment cover can only be closed with a dust filter bag in place. 4.2 Changing filters Your vacuum cleaner is equipped with the following filters: Motor protection filter (Fig.
4.4 Changing the motor protection filter 1. Switch off the vacuum cleaner and remove the dust filter bag as described in Chapter 4.1, "Changing the dust filter bag", steps 1 thru 4. 2. Remove the filter holder with motor protection filter (Fig. 22/1). Your first flip the filter holder forwards and then pull the filter up and out. 3. Remove the motor protection filter (Fig. 23/1) from the filter holder (Fig. 23/2) over a dustbin. 4. Clean the filter holder. 5.
Canister- Electric Power Nozzle – Problem – electric power nozzle does not power up (motor does not turn on in power nozzle) Solution – Please follow all the steps below and try again a. Unplug cord from power nozzle on hose, count 20 seconds, then plug back in b. Make sure hose is firmly “snapped” into canister c. Make sure main electrical wand is firmly “snapped” all the way to the hose. d. Make sure main electrical wand is firmly “snapped” all the way into the power nozzle e.
Hose – Problem – Hose pulls apart. This is usually caused from pulling too hard on the hose during use. Solution –Only attempt to this fix if you are mechanically skilled. Prolux authorized service center. If this is too complex for you, then contact your Unplug the vacuum from the electrical outlet. Remove the hose. Remove the screws on the hose end that has come loose. Note the exact order in which everything came apart. Rethread the hose end.
contact your authorized PROLUX retailer you bought the unit from first. Unauthorized warranty claims may be sent back. Authorized Warranty claims: PROLUX shall be responsible for all parts and labor and the customer shall be responsible for all shipping charges to and from the PROLUX service center. We are constantly striving to improve our products. Therefore, the specifications contained herein are subject to change without notice. .
