Use and Care Manual

- 7 -
ASSEMBLY INSTRUCTIONS
Assembling your Prolux Flight vacuum cleaner
NOTE: Always remove the power plug from the wall outlet and or remove the battery before assembling or
removing accessories.
1. Insert the male end of the aluminum wand into the main handheld motor unit and press together, until you
head an audible “click”. (PIC 1)
2. Insert the power nozzle into the female end of the aluminum wand and press together until you head an
audible “click”. (PIC 2)
3. Attach the Onboard tool caddy to the aluminum wand, and secure the caddy to the wand by aligning the hole
on the caddy to the hole on the wand and install the included screw to hold it into place. Then press the
attachments onto the caddy.
4. Install the battery – To install the battery, you will need to open the top of the main handheld motor unit, to
access the battery compartment and insert the battery. To open the battery compartment, you will press the little
blue button on the back of the handle, just below the on/off button, this will release the top lid and allow access
to the battery compartment (PIC 3 – PIC 4)
5. To disassemble the main handheld unit and power nozzle from the main aluminum wand, you will press the
release buttons, which are located on each end of the wand, and pull the handheld unit or power nozzle away
from the wand. (PIC 5 – PIC 6)
WARNING
To reduce the risk of electric shock, the power cord must be disconnected or battery
removed before removing the dust container, changing the filters or performing
maintenance or troubling shooting checks