Use and Care Manual

The Rough Polishing Brush Disc is composed of Nylon brushes and is used for aggressive cleaning and
scrubbing. Users tend to use this brush for tile and grout scrubbing and hardwood floor stripping.
·Fine Polishing Seat + Polishing Fine Pad:
The Fine Polishing Seat + Floor Polishing Fine Pad is used for final polishing, buffing or cleaning of floor
surfaces. It may also be used briefly on carpet surfaces if one of the Fine Polishing Seat + Polishing Fine Pad’s
are removed. In case the user is using the unit to wax your hardwood floors the polishing fine pad would be
used in final step to polish floors.
·Fine Polishing Seat+ Polishing Scouring Pad:
The Fine Polishing Seat + Floor Tile Polishing Scouring pad is used for scrubbing and cleaning floors. It can
be used to scrub all floor surfaces BUT beware that it can cause permanent scratching on fine surfaces like
wood surfaces. Always check with your floor manufacture first and test a small area before proceeding with
this step.
Steps to Cleaning:
For most (not all) floor surfaces the following steps are typically used to clean.
1. For aggressive stains and cleaning use the “Rough Polishing Brush Disc” and user may use spraying
method of unit to spray cleaner on floor surface while cleaning.
2. For stains not as aggressive user may use the “Fine Polishing Seat + Scouring Pad” and user may use
spraying method of unit to spray cleaner on floor surface while cleaning.
3. Final Cleaning Method is to use “Fine Polishing Seat + Polishing Fine Pad” to clean up left over
moisture on floors and for final polishing.
Precautions:
·During use, please be sure to use the Fine Polishing Seat. If the user discovers that the machine has
increased resistance during use, please stop the machine immediately to check it and ensure that the Fine
Polishing Seat is dry. If you have any questions, please contact your authorized dealer you bought the unit from.
The motor of the unit has a build over use mechanism which will turn off the unit if it is being used to hard. If this
occurs check unit to make sure nothing is causing increased resistance. If unit turns off again avoid cleaning
that surface.