Use and Care Manual

Supplementary instruction of cleaning:
If the surface of the Rough Polishing Brush Disc and floor
polishing fine pad has condensed wax water and dirt, it can be
immersed in a suitable amount of warm water with enzymatic
laundry powder for about 20 minutes and then rubbed.
FAQs
Frequent Problem
Possible Cause
Solution
The polishing head
motor doesn’t rotate
It is not powered on
Check if the power socket is firmly
inserted into the wall outlet and the
handle is fully released all the way down
to a working state.
Sharp friction sound
during waxing
Foreign matters in the
brush disc
Check if there are granular hard objects
on the floor and under the waxing head
and clean them.
Running resistance
obviously increases
during waxing
The brush disc has
foreign matters or it is
immersed in liquid
Check if the Fine Polishing Seat and floor
fine polishing fine pad (floor tile fine
polishing scouring pad) is dried.
The floor wax is not
dried.
Time is insufficient
Polish it again after the floor wax is dried.
Floor gets to dry
during spraying
solution mode.
Not enough spray
Make sure nozzle is not clogged and
slow down polishing movement of side to
side until there is enough solution on
floor.