Use and Care Manual

4. Solution
spraying
switch and
indication
The solution spraying switch can only control the spraying pump. When the user presses
the solution spraying switch the switch turns on and a green indicator light will turn on.
When this happens, it will enter into the pre programmed solution spray work cycle. This
is where it will spray solution then pause for several seconds and spray solution again. It
is designed so right when you run out of solution or wax on your floors then it spays
again. If you have run out of solution before it sprays on the next automatic spray then
slow down your polishing movements of the unit until the sprays are perfectly timed. If
you need it to spray manually you turn on the spray switch then after it sprays turn off the
switch and repeat this until you have the desired amount of manual spray.
Note: This unit is designed for residential use. It is recommended that the machine
shouldn’t be continuously used for more than 30 minutes at a time, which can be
restarted after several minutes of the unit cooling down.
5. Drying
If your application requires that you allow your floors to dray after solution or wax
application allow at least 15 minutes or until your floor is dry.
6. Rough
Polishing
Cleaning
Mode
Insert the power cord; slightly step on the upper cover of the waxing head with feet; pull
the handle to form a proper working angle between the extension pipe of the floor waxing
machine and the waxing head. Push the handle part of the floor waxing machine to drag it
back and forth, and use the Rough Polishing Brush Disc for uniform polishing on the
ground, please uniformly polish every square yard of floor for more than one minute
5.Wax coating
and Rough
Polishing
Mode
Insert the power plug; slightly step on the upper cover of the waxing head with feet; pull
the handle to form a proper application angle between the extension pipe of the floor
waxing machine and the waxing head. Push the handle part of the floor waxing machine
to drag it back and forth,
In such case, activate the wax spraying function and uniformly spray Wax or essential oil
(as specified by the floor manufacturer).
For uniform rough polishing on the floor, please uniformly polish every square yard of
ground for more than one minute.
6. Drying
After waxing and rough polishing mode, allow at least 15 minutes to dry the floors (or until
floors are properly dried).
7.Fine
polishing
Use the Fine Polishing Seat and perform fine polishing to the floor with the same
polishing method (as mentioned in #5 above) until the floor is polished.