Use and Care Manual

REMEMBER THE FOLLOWING WHEN USING YOUR VACUUM CLEANER:

1. Before using the machine pick up by hand any hard or sharp objects such as pins, hairpins, thumbtacks, pieces of

pencil, etc. that could harm the spinning brush roll. 󳆫

2. Do not lubricate the motor. The motor has permanent lubrication and is sealed. 󳆫

3. Shut down the machine before connecting or disconnecting hose. 󳆫

4. Do not use the machine to clean chimneys, open stoves, or other materials containing 󳆫oils, grease, soot, ashes,

clay dust, plaster or other water-resistant materials. 󳆫

5. Do not use the machine without water in the bowl unless you’re going to be using it for wet pick up. When being

used for wet pick up leave the water bowl empty since you’ll be ﬁlling it with the liquid being picked up.

Preparation:

1. Fill the water bowl with the required amount of water, which should be just below the stem in the bottom of

the bowl. NOTE: If you’re going to be using added fragrance oil add this to the bowl now

2. Ensure the Hydro Turbine is installed and in place correctly

3. Mount the motor unit onto the water bowl and lock it into place

Basic Functions:

1. Air Cleaning - Place the motor unit in a centralized area of the room and turn the power switch to the low

setting. Let the unit run for the desired time, which the size of the room will determine how long the unit

needs to run for. Once the desired time has been reached turn the unit oﬀ, empty the water bowl, clean and

let it air dry. NOTE: Fragrance oils work great with the vac when using it in puriﬁer mode

2. Vacuuming – Attach desired hose, wand and powerhead or attachments. Turn the power switch on the

main motor unit to the high setting and begin to clean until ﬁnished or the water bowl needs to be changed

and reﬁlled. The water may need to be changed several times depending on the size of the area, but you’ll

always want to keep the water fresh so it’s able to ﬁlter eﬃciently.

Troubleshooting