Use and Care Manual

OPERATION AND HANDLING
General guidelines for using the CTX:
Fill up the water bowl with cold water until it almost covers the top of the central post inside the
water bowl (fig 1)
The motor unit is then placed on top of the water bowl (fig 2). The suction port of the bowl
should be lined up with the notch in the motor unit. The edge of the motor unit should firmly rest
on the top of the water bowl, and be inside of the retaining ring for correct location, otherwise
the machine will not work. This is because of the safety switch located on the underside of the
motor unit. Engage the two clamps, catch the lower latch piece to the water bowl tabs and push
the upper latch piece towards the motor unit locking the latches in place. Once the water bowl
has been latched to the motor unit place the machine on top of the wheeled base. Note: The
clamps will not operate properly if the motor unit is not in the proper position on the water
container. If the clamps do not operate easily, check the location of the motor unit.
Whichever hose you choose to use can now be connected to the water bowl port and locked into
place. Just insert the hose end into the port and twist to lock into place. You can now attach the
10