Use and Care Manual

TO CLEAN AND REPLACE THE EXHAUST HEPA FILTER:

1. Open the exhaust cover by rotating it counter clockwise. (Fig. 13)

2. Pull the exhaust HEPA out of the unit. (Fig. 13)

3. Clean the filter using warm water, and allow air-drying completely, and then place the filter back into the unit. Or,

if the filter is too dirty, or in an unusable condition, replace the filter with a new one.

Fig 13

CLEANING THE HOUSING:

WARNING: Always switch off the appliance and disconnect it from the outlet before cleaning it. See section "Switching

Off and Retracting Power Cord.”

ATTENTION

: Do not use Alcohol, cleaning, or scouring agents to clean your machine, as these may damage the

appliance. Clean the outside of the housing using only a slightly damp washcloth with mild soap.

- 16 -