Prolux 2.0 Commercial Bagless Backpack Vacuum Commercial Power Nozzle Kit : Use and Care Manual : Page 11

ASSEMBLY AND OPERATING INSTRUCTIONS

NOTE:

 Always remove the power plug from the wall outlet before assembling or removing accessories.

ATTACHING THE FLEXIBLE HOSE & TELESCOPIC WAND TO THE

VACUUM

The flexible hose should be connected before strapping the unit on.

1. To connect the flexible hose to the unit, insert the hose connector into the air inlet, then take the small

2-prong power cord coming from the hose and plug it in to the 2-prong receptacle next to the air intake port.

(Fig. 1)

2. Insert the handle of the electric power hose (Fig. 2) into the upper end of the electric telescopic wand. Be

sure to align the 2 prong electrical connections as you press the two pieces together. (Fig 3).

3. Attach the electric power nozzle (Fig. 2) to the bottom end of the telescopic wand. Be sure to align the 2

prong electrical connections as you press the two pieces together. (Fig 2).

4. Adjust the length of the telescopic wand. Press down the release latch on the wand to do this (Fig. 4). Then

pull the handle of the telescopic wand to extend it to your desired length. Let go of the release catch while

pulling until it locks in place. You will hear a distinct click.

- 9 -