Congratulations on purchasing your very own Prolux 2.0 Bagless Backpack Vacuum! The Prolux 2.0 is the world’s ONLY bagless backpack vacuum. Because backpack vacuums can cut cleaning time in half, many companies use them to clean commercial buildings. Now you too can enjoy up to 50% less cleaning time! Weighing only 9lbs., and with 125 CFM, this vacuum is over 40% lighter and more powerful than the competition! The Prolux 2.
Table of contents Specifications 3 Optional Accessories 4 Safety Precautions 5 Assembly 7 Getting To Know Your Vacuum 7 Using The Accessories & Tools 10 Operation Operating Instructions/Adjusting The Harness 13 Maintenance Emptying The Dust/Dirt Container 14 Changing/Cleaning The Intake Vortex Filter 14 Changing/Cleaning The HEPA Exhaust Filter 15 Cleaning The Housing 15 Troubleshooting 16 Warranty 17 -2-
Specifications ● Lightweight – Only weighs 9 lbs. ● Powerful 1400 Watt, 12 amp motor ● Amazing 125 Cubic Feet per Minute of Airflow! (Most vacuums only have 80 CFM) ● 95 Inches of Water Lift ● Motor Bypass valve, which adds years of life to the Motor ● 3 Year motor Warranty and 3 Year body Warranty. (See Warranty Section) ● Cleans twice as fast as standard Upright Vacuums. ● 3-Stage filtration: ○ HEPA H13 Filter, which keeps the air clean with 99.
OPTIONAL ACCESSORIES The Prolux 2.0 Power Nozzle attachment – This attachment is great for areas where the majority of the flooring is carpet or rugs. With its electrically powered spinning brush-roll, this is the perfect attachment to deep clean any carpeted surface.
IMPORTANT SAFETY INSTRUCTIONS READ ALL INSTRUCTIONS IN THIS OPERATING MANUAL BEFORE USING THIS APPLIANCE. When using an electrical appliance, basic precautions should always be followed, including the following: Keep the operating manual for reference. Include the operating manual if you pass the appliance to third parties. Violations of the operating instructions can lead to severe injuries as well as damage to the appliance.
Do not vacuum or clean: - Hair and other parts of the body. They could be sucked in and cause injury. - Pieces of Clothing (e, g, shoe laces, scarves, etc.). They could be sucked in and cause injury. - Water and other liquids, especially moisture from carpet cleaning agents. Moisture inside the appliance can lead to short-circuiting. - Toner dust (from laser printers. copying-machines. etc.). There is danger of fire or explosion. - Hot ash, burning cigarettes or matches. This could cause a fire.
GETTING TO KNOW YOUR BACKPACK VACUUM 1. Main Motor Unit 2. Dust Container 3. Flexible Hose 4. Shoulder Straps 5. Exhaust HEPA Filter 6. Air Inlet Vortex Filter 7. Carpet/Floor Brush 8. Crevice Tool 9. Upholstery/Pet Hair tool 10. Dusting Brush 11. Mini Turbo/Pet Tool 12. Quick Adjusting Telescoping Wand 13. Squeegee Blade 14. Squeegee Floor Tool 15. ON/OFF Power Switch 16. Tool Adapter 17. Self-Cleaning Filter Cone 18. Additional Tool Storage 19.
ASSEMBLY AND OPERATING INSTRUCTIONS NOTE: Always remove the power plug from the wall outlet before assembling or removing accessories. ATTACHING THE FLEXIBLE HOSE & TELESCOPIC WAND TO THE VACUUM The flexible hose should be connected before strapping the unit on. 1. To connect the flexible hose to the unit, slide the hose connector over the air inlet (Fig 1). 2.
-9-
USING THE ATTACHMENTS DUSTING BRUSH The Dusting Brush is used for all types of furniture. (Fig 3) CREVICE TOOL Use for cleaning radiators, cracks & crevices along corners, baseboards, and in-between cushions. (Fig 4) PET HAIR REMOVAL BRUSH The unique design makes it an excellent tool for removing unwanted pet hair from virtually any surface. (Fig 5) NOTE: This tool is not a grooming tool and should not be used on animals.
CONNECTING THE ATTACHMENTS TO YOUR WAND NOTE: When using the Duster, Crevice, and Upholstery Tool, make sure to use the adapter provided with your Backpack Vacuum Cleaner. Connecting the tools to your telescopic wand is quick and easy. The tools use a Friction Fit Connection which means you push the tool on to the wand (or adapter if applicable) and twist in either direction.
PROPER VACUUMING TECHNIQUE WITH THE PROLUX 2.0 FLOOR TOOL When vacuuming with your Prolux 2.0, you may vacuum using the standard forward and backwards vacuuming motion as you would with standard vacuum cleaners. However, because of the new Prolux 2.0 floor tool design, you can vacuum an area by vacuuming in half circle motions and vacuum the same area twice as fast. ● Start by holding the wand as seen in (Fig A).
USING YOUR VACUUM 1. Insert the power plug into the wall outlet 2. Connect hose and telescopic tube if desired. 3. Correctly place shoulder straps on each shoulder and secure the waistband strap. (Fig 8 through Fig 8b) Caution: If the waistband and both shoulder straps are not properly and securely in place, the unit could fall off your back, causing damage or injury. 4. Turn the unit on/off by pressing the switch located near the base of the unit.
HOW TO EMPTY THE DUST CONTAINER The dust container must be emptied as soon as it reaches the “MAX” mark indicated on the outside of the tank, or if the suction power has dropped. To empty the Dust Container, please follow the instructions below: 1. Switch the vacuum cleaner to the “Off” position and disconnect the plug from the wall outlet. 2. Release the dust container by pressing down the release button. (Fig 10) 3. Pull the dust container away from the vacuum cleaner. 4.
NOTE: The Prolux Self-Cleaning Vortex filter only needs to be cleaned when the entire surface of the filter becomes dirty. Due to its highly efficient design the Self-Cleaning Vortex filter is three times more efficient than standard filters and will have the same amount of airflow whether it’s dirty or clean. The entire surface of the filter will have to be covered in debris before the performance of the vacuum is affected, and the filter needs to be cleaned.
Troubleshooting WARNING: Never use a defective appliance. Always switch off the appliance and disconnect it from the outlet or remove the battery before you start to troubleshoot. Fault Possible Cause(s) Solution The vacuum will not turn on. The plug is not connected to the electrical wall outlet or the appliance is not switched to the “on” position. Electrical wall socket does not carry current. Insert the plug into an electrical wall outlet and flip the “on/off” switch to the “on” position.
THREE (3) YEAR LIMITED WARRANTY Prolux warranties this product’s motor free from defects in material and workmanship for a period of three (3) years on the motor, and three (3) years on the body of the vacuum, free from manufacturer defects in material and workmanship from the original date of purchase, when utilized for normal household use. Subject to the following conditions, exclusions, and exceptions: What is Not Covered by the Prolux Warranty - Warranty Exclusions.
Product Warranty Registration Please follow the link below to register your Prolux product: https://proluxcleaners.com/pages/warranty For more information on this product, including warranty info and to contact Prolux Customer Service, follow the link below: https://proluxcleaners.
