Setup guide

Configure the DFNT Module 6201-WA-ASCII ♦ ProLinx Wireless
High Speed Wireless ASCII Generic Serial Gateway
ProSoft Technology, Inc. Page 29 of 50
September 6, 2007
Both the ASCII and the DFNT have corresponding Produce and Consume
commands. The following diagram illustrates the sample application:
6201-WA-ASCII (Primary Client)
6201-WA-DFNT (Remote Client)
PWP Exchanges
Note: The sample configuration file also shows an additional Produce and Consume
command. These commands are designed to pass a time value from the DFNT to the
ASCII module and then loop back from the ASCII to the DFNT. These commands are
included for testing and radio communication verification purposes only and are not
necessarily required for your application.
4.1.5 Radio PWP Multicast Group List
This section does not contain any data for the sample application. The sample
application uses UNICAST transmission and therefore there is no need to enter
IPs of other devices in this section. The ProLinx PWP Driver Manual describes
this section in detail.
4.1.6 DFNT Client 0
The sample configuration file requires that the module currently being configured
be configured as a Client. This is done in the DFNT Client 0 section.
1 Double-click on the
icon.