Setup guide

6201-WA-ASCII ♦ ProLinx Wireless Configure the DFNT Module
High Speed Wireless ASCII Generic Serial Gateway
Page 28 of 50 ProSoft Technology, Inc.
September 6, 2007
1 Producer Command Narrative for the First Command (line 3):
2 Send data using Unicast Mode
3 Send the data to IP Address 172.16.10.160.
4 Send 600 registers beginning at DB Register 1200.
5 Do not set a Swap Code.
6 Send the data every 100 milliseconds.
7 Use an Exchange ID of 1002.
Producer Command Narrative for the Second Command (line 4):
1 Send data using Unicast Mode
2 Send the data to IP Address 172.16.10.160.
3 Send 600 registers beginning at DB Register 1800.
4 Do not set a Swap Code.
5 Send the data every 100 milliseconds.
6 Use an Exchange ID of 1003.
Note: IP Address 172.16.10.160 is the 6201-WA-ASCII module.
The Consume commands receive data coming into the module from the DFNT
once configured.
1 3 4 5 2 6
Consumer Command Narrative for the First Command (line 1):
1 Consume data using Unicast Mode.
2 Consume this data only from IP Address 172.16.10.160.
3 Consume 600 words and store them beginning at DB register 0.
4 Do not use a Swap Code.
5 Consume data within 400 milliseconds.
6 Only consume data with an Exchange ID of 1000.
Consumer Command Narrative for the Second Command (line 2):
1 Consume data using Unicast Mode.
2 Consume this data only from IP Address 172.16.10.160.
3 Consume 600 words and store them beginning at DB register 600.
4 Do not use a Swap Code.
5 Consume data within 400 milliseconds.
6 Only consume data with an Exchange ID of 1001.