Manual

ManualsBrandsPROLiNK ManualsComputer AccessoriesPRO700 EnerHome

Summary of content (12 pages)

PAGE 1
PAGE 2
Blk 16 Kallang Place #06-02 Singapore 339156
PAGE 3
1. CAUTION English The UPS battery has been fully charged before leaving our factory. During the shipment, some level of power may have been discharged. In order to ensure the efficiency of the UPS, please allow the UPS to charge its battery for at least 12 hours before use. Connect the UPS to a two-pole, three-wire grounding mains (AC). The AC source must be connected to appropriate branch protection (fuse or circuit breaker).
PAGE 4
2. OPERATION 2.1 Operating Instructions A. Connect the AC input power cable of your UPS to the AC Power. ‘YELLOW’ LED on the UPS front panel is lit. UPS is charging the battery. (Note: DO NOT connect any load to your UPS until the UPS has charged its battery for 12 hours) B. Plug computer and monitor to UPS sockets. (Note: Power of computer and monitor must be less than the maximum total power of your UPS. DO NOT connect a laser printer to the UPS backup socket.
PAGE 5
2.3 Front / Rear Panel Explanation Yellow LED ON when UPS is offline charging battery. Blinking when AC is abnormal. Green LED ON when UPS is running normal. OFF when UPS is off or abnormal. Red LED : On only when UPS is fault MAIN Switch : Control UPS On/Off A. AC Inlet B. Backup Outlets C. AC Fuse Holder (W/fuse) 2.4 Troubleshooting Problem Green LED does not light up when UPS is turn on. Yellow LED is blinking and UPS is beeping. UPS beeps occasionally on AC mode and UPS may be heated up.
PAGE 6
3. SPECIFICATIONS Model PRO700 Capacity Input 650VA Voltage Range 140 – 300VAC ± 5VAC Frequency > 40 Hz Phase Output Single + GND Voltage Range 230VAC + 11% - 17% Battery Mode 230VAC ± 10% Frequency 50Hz ± 1Hz (Battery Mode) Waveform Simulated Sine Wave (Battery Mode) Sine Wave (AC Mode) Transfer Time Battery 2ms typical Type & Number 12V8.
PAGE 7
1. PERHATIAN Bahasa Indonesia Baterei UPS sudah diisi penuh sebelum keluar dari pabrik. Selama pengiriman, kapasitas dari isi baterei akan berkurang. Untuk memastikan efisiensi dari UPS, sebaiknya baterei diisi kembali sebelum digunakan selama 12 jam. Hubungkan UPS ke pusat listrik dengan menggunakan kabel 3 pin (berikut grounding). Grounding ini sangat berguna untuk memproteksi peralatan kita dari petir. UPS ini mempunyai baterei internal dan energi nya tidak bisa dibuang.
PAGE 8
2. PENGGUNAAN 2.1 Instruksi Penggunaan A. Sambungkan kabel power dari UPS ke sumber listrik (PLN). Lampu ‘KUNING’ akan menyala. Artinya UPS sedang melakukan charging ke baterai. (Note: JANGAN dulu menggunakan UPS anda sampai baterai dari UPS anda sudah di charge selama kurang lebih 12 jam). B. Sambungkan komputer dan monitor anda ke output UPS. (Note: Total daya dari komputer dan monitor harus lebih kecil dari kemampuan output daya maximum dari UPS anda.
PAGE 9
2.3 Penjelasan Panel Depan Lampu KUNING HIDUP ketika UPS sedang melakukan Proses charging BERKEDIP ketika sumber listrik (PLN) padam Lampu HIJAU HIDUP ketika UPS bekerja normal. MATI ketika UPS mati atau tidak normal. Lampu MERAH HIDUP UPS overload, atau bermasalah MAIN Switch Untuk mengontrol UPS HIDUP / MATI A. AC Inlet B. Backup Outlets C. AC Fuse Holder (W/fuse) 2.4 Permasalahan Dan Solusi Masalah Lampu HIJAU tidak menyala pada saat UPS dihidupkan. Lampu KUNING berkedip dan mengeluarkan bunyi Beeps.
PAGE 10
3. SPECIFICATIONS Model PRO700 Capacity Input 650VA Voltage Range 140 – 300VAC ± 5VAC Frequency > 40 Hz Phase Output Single + GND Voltage Range 230VAC + 11% - 17% Battery Mode 230VAC ± 10% Frequency 50Hz ± 1Hz (Battery Mode) Waveform Simulated Sine Wave (Battery Mode) Sine Wave (AC Mode) Transfer Time Battery 2ms typical Type & Number 12V8.
PAGE 11
TECHNICAL SUPPORT FREE TECHNICAL SUPPORT HOTLINE: Mon to Fri: 9am - 6pm (Closed on Saturdays, Sundays & Public Holidays) Singapore : (65) 6357 0666 Malaysia : (60) 3 8023 9151 Indonesia : (62) 21 628 3205 OPERATING HOUR: Mon to Fri: 9am - 6pm (Closed on Saturdays, Sundays & Public Holidays) Singapore FIDA INTERNATIONAL (S) PTE LTD Blk 16 Kallang Place #06-02 Kallang Basin Industrial Estate Singapore 339156 Malaysia FIDA SYSTEMS (M) SDN BHD 29 USJ 1/31, 47600 Subang Jaya Selangor, Darul Ehsan, Malaysia
PAGE 12
Register Online For Your Product Warranty www.prolink2u.com SINGAPORE FIDA INTERNATIONAL (S) PTE LTD Block 16 Kallang Place, #06-02 Kallang Basin Industrial Estate, Singapore 339156. Tel : (65) 6357 0668 Email : support@fida.com MALAYSIA FIDA SYSTEMS (M) SDN BHD 29 Jalan USJ 1/31, 47600 Subang Jaya, Selangor Darul Ehsan, Malaysia. Tel : (60) 3 8024 9151 Email : support_my@fida.com INDONESIA PROLiNK INDONESIA P. Jayakarta Komplek 85 BR/AJ, Jakarta Pusat - Indonesia.