User Manual

Step3. Adjust the laptop and monitor extension setting

(Refer to Secon 2 of Chapter 3 for monitor

display seng.)

Aer powering on the laptop, go to

Windows’ "Control Panel" to adjust the

monitor extension seng.

If you are using Windows 7:

Select "2.DVI LCD" (Digital Video) or

“2. display device: VGA” (Analog Video) for

Display.

Select "1366x768" for Resoluon

Select "Landscape" for Orientaon

Select "Extend these displays" for Mulple

monitors, and drag Display 2 to the right side

of Display 1.

Section 2 Vertical Display

Step1. Install the Video and USB-Powered cable

If you wish to use the HDMI port on the laptop, please use Digital Video and USB-

Powered Cable. If you wish to use the D-sub (VGA) or mini-Display Port on the lap-

top, please purchase the Analog Video and USB-Powered Cable or mini-DisplayPort

and USB-Powered Cable from our authorized service center.

Connect the Video and Power connector to Mobile Monitor Video port, (1) Insert

the latch into the groove of the video power connector. (2) Slide the video power

connector toward the le for a proper connecon. [WARNING: Not inserng the

latch into the groove may result in damage to the connector. Please check the video

power connector is properly connected and not protruding out. If protrusion occurs,

the connecon might not be properly connected and monitor will not be able to

operate.]

Fig.: Insert the video power connector to the video power port of Mobile Monitor