User Manual

2. Rotate the Mobile Monitor clockwise so that it is parallel to the laptop, open the

laptop monitor and the Mobile Monitor at the same me, as illustrated.

3. Adjust the angle of the Mobile Monitor. A recommended angle is between 180°

and 225°.

4. Connect the Video and power cable

As illustrated, connect the USB-Powered connector to the laptop's USB port, and

then the Digital Video connector to the lap-

top's HDMI Video output port

● If Analog Video and USB-Powered cable is

used, connect the Analog Video connect-

or to the laptop's D-sub port

● If miniDP and USB-Powered cable is used,

connect the miniDP connector to the

laptop's D-sub port

Fig.: Dual monitor display mode

5. As illustrated, move the Mobile Monitor upward from the laptop’s front cover,

press on the posioning clip at the rst posioning hole, and move the Mobile

Monitor unl the posioning clip pops up from the second posioning hole.

Fig.: Moving the posioning clip from the rst posioning hole to the second

posioning hole. Aer Mobile Monitor moves up, it is no longer xed to the boom of

the laptop, and the laptop’s monitor can be lted backward.

[Note: If your laptop is smaller than Mobile Monitor, the cable may get stuck when

ipping the Monitor (see upper right gure). Follow the steps above to adjust the

monitor height.]

Fig.: Rotate the Mobile Monitor to the

right side, then open the laptop

monitor and the Mobile Monitor at

the same me.

Fig. A recommended angle is

between 180° and 225°.