Operation Manual
Downloaded from www.vandenborre.be
Cleaning the door
Clean periodically the interior part of the
door to remove any fluff. Accurate cleaning
ensures correct drying.
Cleaning the drum
Caution! Do not use abrasives or steel
wool to clean the drum.
Lime in the water or cleaning agents
may form a barely visible lining on the
inside of the drum. The degree to
which the laundry has been dried is
then no longer detected reliably. The
laundry is damper than expected when
removed from the dryer.
Use a standard domestic cleaner (e.g.
vinegar-based cleaner) to wipe down
the inside of the drum and drum ribs.
Clean operating screen and housing
Caution! Do not use furniture cleaners
or aggressive cleaning agents to clean
the machine.
Use a damp cloth to wipe down the
operating screen and housing.
What to do if ...
Troubleshooting by yourself
Problem
1)
Possible cause Remedy
Dryer does
not work.
Dryer not connected to mains supply.
Plug in at mains socket. Check fuse in
fuse box (domestic installation).
Loading door opened. Close loading door
The START PAUSE button not pressed. Press the START PAUSE button.
Unsatisfactory
drying results.
Incorrect programme set.
Set suitable programme.
2)
Fluff filters clogged.
Clean fluff filters.
3)
Max. loading exceeded. Respect max. loading volume.
Covered ventilation grill. Uncover ventilation grill in base area.
Residue inside the drum. Clean the drum inside.
To little free space around the appliance
Ensure min. 5cm free space around the
appliance
Loading door
does not
close
Filters not locked in place.
Install fine filter and/or snap course filter
into place.
Drying cycle
to short
Small laundry volume./Too dry laundry
for selected programme.
Select time programme or higher drying
level (e.g. EXTRA DRY ).
Drying cycle
to long
4)
Fluff filters clogged. Clean fluff filters.
To high loading volume. Respect max. loading volume.
Laundry insufficiently spun. Spun adequately the laundry.
Particularly high room temperature - no
machine fault.
Lower the room temperature if possible.
1) Switch the dryer off. Set programme/time. Press the START PAUSE button.
2) follow program recommendation - see Programme overview chapter
3) see Care and cleaningchapter
4) Note: After around 5 hours the drying cycle ends automatically (see Drying cycle complete section).
25