Operation Manual

5
3. Lift the filling cap and fill with water up to the MAX fill line. Replace the
filling cap.
x It is recommended to use purified water.
4. Attach the water tank back to the base unit until a click is heard.
5. Make sure that the iron is placed properly on the thermal insulation pad.
6. Plug the appliance to the mains socket and press to turn on the appliance.
x
The indicator light will illumiante.
7. Turn the temperature dial to your desired setting.
x The temperature indicator light on the iron will illuminate.
8. When the temperature indicator light on the iron goes out, the set temperature has been reached
and the iron is ready for use.
9. To obtain continuous flow of steam during ironing, wait for the
steam indicator light to illuminate and then press and hold
the steam trigger to deliver steam through the soleplate.
x
ATTENTION! If there is no steam sprayed out of the
soleplate after pressing down the steam trigger to release
steam for 1 minute, you shall check the water in the water tank. If there is less water left in the
water tank, you shall refill the water tank.
x To refill the water tank, please turn off and disconnect the appliance from the mains socket.
Slide out the water tank and then refill with water up to the MAX fill line.
Dry Ironing
To iron without steam, first connect the appliance to the mains socket and then press to turn
on the appliance. Select the desired temperature by turning the temperature dial. Wait until the
temperature indicator light goes out, indicating that the desired temperature has been reached.
For dry ironing it is not necessary to press and hold the steam trigger.
Downloaded from www.vandenborre.be