Operation Manual

Downloaded from www.vandenborre.be

Using Steam Function

Make sure that there is water in the reservoir. Press the steam button to generate a

powerful burst of steam that can penetrate the fabrics and smooth difficult and tough

creases. Wait for a few seconds before pressing again.

By pressing the steam button at intervals you can also iron vertically (curtains, hung

garments, etc.).

arning:

 The steam function can only be used at high temperatures. Turn the

thermostat knob within the steam range. Stop the emission when the red

power light comes on, then start ironing again only after the light has

gone off.

 For delicate fabrics, we recommend moistening the fabric beforehand using the

steam function, or putting a damp cloth between the iron and the fabric. To avoid

staining, do not use the steam on silk or synthetic fabrics.

DRY IRONING

Even if with water in the reservoir, the iron can also be used as dry iron. Turn off the

steam by pressing - repeatedly until appears on the LCD. When the power

light goes out, the iron reaches the ideal temperature.

SETTING WATER HARDNESS

. Press and hold + and - until water hardness indicator blinks on the LCD.

2. Press + or - repeatedly to select water hardness you are using.

: Soft water : Hard water : Very hard water

3. A beep sounds to confirm the selected water hardness.

REPLACING ANTI-CAL CARTRIDGE

The appliance has an electronic system monitoring the water hardness.

The anti-cal cartridge will purify the water and remove the permanent and temporary

hardness. There are anti-scale resins in the cartridge. Depending on the water

hardness and actual usage, the cartridge needs to be replaced from time to time.