Operation Manual

Downloaded from www.vandenborre.be

FIRST TIME IRONING

1. Remove any protective films or sticker from the soleplate and the cabinet if any.

2. Unwind and straighten the power cord and steam pipe.

3. Fill the tank with tap water. (See 'FILLING THE TANK'.)

4. Put the iron on the base, the lumpy bits on top are heat-resistant.

5. Insert the plug into the mains socket with a beep heard. Turn the thermostat knob

to the maximum setting.

6. Press the power ON/OFF button with a beep heard.

 The red power light on the iron will come on to ind

icate the iron is heating up.

 blinks on the LCD to indicate the base is heating up.

7. When the base reaches the required temperature, will disappear on the

LCD.

8. When the red power light goes off, it indicates that the iron has reached the

required temperature and is ready to use.

9. Press and hold the Steam button for 1 minute to clean the steam generating

system.

10. Begin first time ironing with an old towel.

STEAM IRONING

Selecting the steam

Press + or - repeatedly to select the desired steam level. The corresponding icon will

appear on the LCD.

: Low steam level

: Medium steam level

: High steam level

Selecting the temperature

Adjust the thermostat knob according to the international symbol on the garment

label. Wait until the red power light comes on before ironing.

If you lower the thermostat temperature after ironing at a high temperature, do not

start ironing until the power light comes on again.