Operation Manual

Downloaded from www.vandenborre.be

GARMENT

LABEL

FABRIC

TYPE

THERMOSTAT

REGULATION

synthetic

low temperature

silk - wool

medium temperature

Cotton - linen

high temperature

Fabric not to be ironed

Start ironing the garments requiring a low temperature.

This reduces the waiting times (the iron takes less time to heat up than to cool down)

and eliminates the risk of scorching the fabric.

The appliance has a high technology low-pressure steam chamber that can be

heated up in short time. Water is converted to steam vapour in the chamber and

transported to the iron unit through the steam pipe.

Using the Cable Support

1. Unwind and straighten the supply cord.

2. Install the cable support as shown.

3. Place the steam pipe onto the hooks of the cable

support.

FILLING THE TANK

. Check that the plug is disconnected from the socket and the iron is cool.

2. Slide out the water tank.

3. Open the water inlet cover to fill the tank with water, taking care not to go over the

maximum level.

4. Close the water inlet cover and replace the water tank.

NOTE: Refilling can be done when the appliance is in use. It is not necessary for the

appliance to cool down.