Operation Manual

Downloaded from www.vandenborre.be

Rotisserie

Pull out the clamps on the spit by

loosening their screws and stick the spit

into chicken. Then, mount the clamps by

sliding them on the spit and stick the

clamps into chicken. Tighten their

screws. Before roasting make sure the

oven and rotisserie functions are turned

OFF. Put the tray on second shelf and

locate the rotisserie bearing bracket for

spit in the holes on the tray as shown in

the picture. Some products may have

rotisserie bearing grid accessory instead

of the rotisserie bearing bracket for spit

and tray can be placed on first shelf.

In this case, you only need to place the bearing grid on third shelf.

Before locating the point tip of spit into hole at back panel of oven, turn the small metalic

cover and see the hole. Place the point tip of spit into hole at back panel of oven and the

bearing tip of spit on the rotisserie bearing bracket or rotisserie bearing grid firmly. Also, be

sure that the point tip of spit is placed into hole firmly. During rotisserie, spit handle must

never be mounted to spit and oven door must be in closed position.

Spit

Rotisserie bearing

bracket or rotisserie

bearing grid

Tray

Spit handle

Spit hole on back

panel of oven

Small metalic

cover

Pan anti-tilting wire

To locate grid correctly in the cavity, put

it to any rack and push the grid up to the

end.

The pan anti-tilting wire must be placed

inside of the cavitiy.

Removal of catalitic panel

Remove G screws on

the each catalitic

enamel coated panel.