Operation Manual

Rotisserie

Pull out the clamps on the spit by

loosening their screws and stick the spit

into chicken. Then, mount the clamps by

sliding them on the spit and stick the

clamps into chicken. Tighten their

screws. Before roasting make sure the

oven and rotisserie functions are turned

OFF. Put the tray on second shelf and

locate the rotisserie bearing bracket for

spit in the holes on the tray as shown in

the picture. Some products may have

rotisserie bearing grid accessory instead

of the rotisserie bearing bracket.

In this case, you only need to place the bearing grid on third shelf.

Place the point tip of spit into hole at back panel of oven and the bearing of the spit on the

rotisserie bearing bracket or rotisserie bearing grid. Also, be sure that the tip of the spit is

placed into the hole correctly. During rotisserie, the spit handle must never be mounted and

the oven door must be closed.

NOTE: The maximum weight the spit will withstand is 4.0Kg.

Spit

Rotisserie bearing

bracket or rotisserie

bearing grid

Tray

Spit handle

Spit hole on back

panel of oven

Pan anti-tilting wire

To locate grid correctly in the cavity, put it to any rack

and push the grid fully home.

The pan anti-tilting wire must be placed inside of the

cavity.

Removal of catalitic panel

Remove G screws on

each catalitic

enamel coated panel.

Downloaded from www.vandenborre.be