Operation Manual

4.4. USING THE DIGITAL TIMER

MODE

Time Adjustment :

The time must be adjusted before starting to use the oven.

Following the power supply to the oven, the symbol (A) and the

three “0” on the screen will begin to flash. Press the MODE

button. The symbol will appear on the screen. Also, the dot in

the middle of the screen will begin to flash. Using the (+) and (-)

buttons, adjust the required time while this dot is flashing. After

setting the time, press the MODE button again. The dot will be lit

continuously.

Minute Timer :

The time must be adjusted before starting to use the oven. Following

the power supply to the oven, the symbol (A) and the three “0” on the

screen will begin to flash. Press the MODE button.

The symbol will appear on the screen. Also, the dot in the middle

Following the power supply to the oven, when the symbol (A) and the three "0" on the

screen begin to flash, the oven cannot be operated using the control buttons. When the

MODE button is pressed for time adjustment, the symbol will appear on the screen. When

this symbol appears on the screen, you can manually operate the oven part. As the

adjusted time will be reset in the event of a power failure, time adjustment operation

willl have to performed again.

Figure 7

Figure 8

of the screen will begin to flash. Using the (+) and (-) buttons, adjust the time while this

dot is flashing. After the adjustment, the dot will be lit continuously. This function can be

used to receive audible warning at the completion of the adjusted time period.

Press the MODE button. The symbol will flash on the screen. Also three “0”s will

appear. Adjust the desired time period for the warning by using (+) and (-) buttons while

the symbol is flashing. Some time after the completion of the adjustment, the symbol

will begin to light continuously. When the symbol begins to light continuously, the

audible warning time adjustment is done.

The audible warning time can be set to a time between the time range of 0 and

23.59.

When the set time is up, the timer gives an audible warning and the symbol begins to

flash on the screen. Pressing any button will stop audible warning and make symbol

disappear from the screen.

Audible Warning time adjustment is for warning purposes only. The oven will not

be controlled by this function.

Downloaded from www.vandenborre.be