User's Manual

User manUal | 9

step 4

step 5

step 6

island hood installation

Install Chimney

♦ slide inner chimney sleeve over support brackets,

covering the ceiling bracket

♦ screw into place at the top of ceiling bracket

♦ slide outer chimney sleeve to the bottom portion

of the chimney

♦ adjust until the bottom chimney sleeve comes a

few inches from the bottom of the support brack-

ets

♦ you may want to use painters tape to help hold

the chimney in place while you proceed to step 5

Attach Hood

♦ if your hood comes with a transition ducting piece,

secure it to the base of your hood before mount-

ing

♦ place the base of the hood directly under the

chimney

♦ screw hood to the support brackets on all 4 cor-

ners

♦ feed electrical and ducting work through chimney

♦ slide outer chimney sleeve down into place, meet-

ing the top of the hood

*first make sure your ductwork and electrical work are pulled through the ceiling and ready to go

(see preparation work and step 2 above)

Install Filters

♦ if your hood will be ductless, install the charcoal

filter (see filter information after the Control Panel

diagram above)

♦ peel off any protective tape or film on the metal

filter

♦ pop the spring loaded metal filter into place, di-

rectly under the hood

♦ That’s it! Now you’re ready to enjoy your new

island hood!