Operation Manual

Downloaded from www.vandenborre.be
UK - 16 -
INSTALLATION
PART 2.
BUILDING INTO THE KITCHEN CABINET
! Before installation, read the instructions carefully.
! Fit the refrigerator in stable kitchen units only.
! If necessary, reverse the door according to instructions.
1. See fig.A for the necessary attachment components.
2. Insert trim flap
(1)
into slot and secure using screws
(6)
. (fig.D)
3. Pass the power cord through ventilation shaft and position it so that the appliance
can be easily plugged in once it has been installed. (fig.B - fig.C)
4. Take out the trim gasket
(4)
located on the side panel of the appliance and stick it on
the rear of of the door hinges. (fig.D - fig.E)
5. Raise the appliance and slide into the kitchen unit.
6. Push the appliance to the rear of the door hinges, make sure that the trim gasket
(2)
covers the space between the appliance and the kitchen unit.
7. Align the front feet with front surface of the kitchen unit. (fig.F)
8. Secure the front feet by using screws
(5)
. (fig.F)
9. Screw trim flap
(1)
to kitchen unit using screws
(5)
. (fig.G)
10. Screw guides
(3)
to appliance door with screws
(6)
. (fig.H)
11. Place the appliance door against the cabinet door.
12. Slide rails
(4)
into guides
(3)
aligning the groove. (fig.H)
13. Screw the rails
(4)
to the unit door with screws
(5)
. (fig.H)
14. Set 1~2 mm gap on handle side between unit itself and unit door by adjusting
guides
(3)
. That is vital for appliance performance. (fig.H)
Figure A