Operation Manual

CLEANING AND MAINTENANCE
Do not use abrasive cleaning agents or solvents.
1. Set the temperature control knob to the 0 position and disconnect the mains plug from the mains
socket.
2. Take out the food and store in a cool location.
3. Clean the appliance with a soft cloth, warm water and detergent.
4. Wipe the door seal with clear water only and then wipe dry thoroughly.
5. After cleaning reconnect and adjust the temperature control knob as desired.
6. Put the food back into the appliance.
Bulb replacement
1. Set the temperature control knob to the 0 position and disconnect the mains plug from the mains
socket.
2. Unscrew the screw and remove the lamp cover.
3. Unscrew the bulb and screw a new 10W (E14 base) bulb.
4. Replace the lamp cover and fix it in place by fastening the screw.
TROUBLESHOOTING
If there is a problem with your appliance, please check the following points before contacting customer
service.
Problem
Possible causes
Possible solution
Appliance does
not operate.
No electricity at power outlet.
Check that the plug is correctly connected
and power switched on.
Noises
Cabinet not stable or level.
See installation section.
Appliance not
cool
Temperature setting not correct.
Frequent door openings.
Large amount of food recently
added.
See temperature control section.
Minimise door openings to allow
temperatures to stabilise.
SPECIFICATIONS
Brand
Proline
Appliance type
Larder fridge
Climate class + Ambient range
ST (+16°C ~ +38°C)
Electric shock protection class
I
Rated voltage and frequency
220-240V~ 50Hz
Input power
90W
Lamp power
10W
Energy consumption
0.350kWh/24h
Refrigerant/Amount
R600a/29g
11
Downloaded from www.vandenborre.be