Operation Manual

Downloaded from www.vandenborre.be
EN -9-
HOW TO OPERATE THE APPLIANCE
THERMOSTAT TEMPERATURE CONTROL PANEL:
The thermostat temperature control is situated between the top and bottom doors which
regulates the temperature of the fridge / freezer.
Thermostat control panel
3200 / tek komp
3250 / çift komp
!
!
Thermostat
Knob
Low ambient
switched on indicator
Power
Alarm
Low ambient
switch
THERMOSTAT SETTING:
• This thermostat Knob regulates the internal temperatures in the Refrigerator and freezer
compartments. By rotating the knob from position 1 - 5, colder temperatures can be
obtained.
• "0" position shows that the thermostat is off, the appliance is switched off but is not
disconnected from the mains supply, to do this remove the plug from the mains outlet.
• When turning on the appliance turn the thermostat control to the maximum position until
the correct operating temperature is reached and then turn back to its normal setting.
• Set the thermostat control knob to a midway position to achieve -18 in the freezer
compartment.
RED ALARM INDICATOR:
Indicates when the temperature is higher than normal for the correct operation of the
appliance. This alarm will also come on when fresh food as been introduced into the freezer
compartment for freezing and when the appliance is turned on for the rst time. This alarm
should go out when correct operating temperature is reached.
GREEN MAINS POWER ON INDICATOR:
This green lamp should be on when the appliance is plug in and connected to the mains
supply.
LOW AMBIENT TEMPERATURE SWITCH:
This switch should only be used when the ambient temperature in the room is expected to
drop below 18 degrees C this function helps to maintain the temperature in the freezer to
maintain -18 degrees C in low ambient temperatures.
Please note: that when this switch is on the appliance uses slightly more energy than normal
so should only be used when necessary.