Operation Manual

Downloaded from www.vandenborre.be

One or all cooking zone cut-off:

 The safety system triggered.

 You forgot to turn off the hob.

 One or more touch keys are covered.

 The pan is empty and its bottom overheated.

 The hob also has an automatic reduction of power level when the hob experiences

overheating

Continuous ventilation after cutting off the hob:

 This is not a failure, the fan continues to protect the electronic device.

 The fan cooling stops automatically.

The control panel displays [ L ]:

 Refer to the chapter: Control Locking on page 24.

INSTALLATION INSTRUCTIONS

Advice for the installer

IMPORTANT

Appliance installation and maintenance must only be carried out by QUALIFIED TECHNICIANS

and in compliance with the local safety standards.

Failure to observe this rule will invalidate the warranty

Installation

How to fit the gasket:

The gasket supplied with the hob avoids all infiltration of liquids in the cabinet.

This installation has to be done carefully, in conformity with the following drawing.

Fitting - installing:

 Cut a hole in the worktop of the dimension shown in the diagram below. Ensure that there

is a distance of 50 mm between the hob and the wall or sides. The worktop should be at

least 30 mm thick and of heat-resistant material.

Stick the gasket (2) two millimeters

from the external edge of the glass,

after removing the protection sheet (3).