Operation Manual


Connecttheotherendtothewaterinletvalveatthebackofthedishwashercabinet.Do
notover‐tightentoavoiddamagetothreads.



Ifleaksarelocated,immediatelyshutthewatersupplyandcheckthehoseconnections
fully.Re‐tightentheconnectionsifnecessary.

Ifforanyreasonyouareunabletostoptheleakyourselfpleaseseekadvicefroma
qualifiedplumber.


POWERSUPPLY

IMPORTANT:
• Themainssocketmustbeaccessibleatalltimes.
• Donotconnectanextensionleadtotheappliancetoavoidpotentialsafetyhazards. 








Connectthestraightconnectoroftheinlethosetothewater
supplysecurelyensuringthatthewashersaresecurelyinplaceat

bothendsofthehose.

7
MAX 1000mm
A
Counter
40mm
B
Insert the drain hose into a drainage pipe or standpipe.
The end of the hose should be dropped into a drainage pipe, the maximum height
of which should be 1000 mm above the base of the dishwasher. The end of the
hose must not be immersed in water to avoid the back flow of it.
To allow for an air gap around the end of the drain hose, the diameter of the
standpipe should be at least 40 mm.
Downloaded from www.vandenborre.be