Owner Manual

WALL HOOD INSTALLATION

First draw these markings on the installation area wall

• Center line of installation area.

• Location of wall studs nearest to the center line. (One on each side)

• Horizontally level line 28-36" above the cook top surface. (Location

of the bottom of the range hood.)

STEP 1

Find location for mounting the range hood

• Trace the outline of your hood on a panel of its cardboard box.

• Find the mounting holes and center point of the hood (directly

between the mounting holes) and mark them on the cardboard panel.

•Carefully cut out the cardboard outline.

• Tape the cardboard cutout panel to the wall lining it up with the

horizontal line (bottom of hood location) and matching the center point

with the center line of the installation area.

• Poke holes through the mounting points on the cardboard marking

the locations on the wall and remove the cardboard.

• If using wall anchors, pre-drill the mounting holes where your marks

are with the correct size bit and insert the wall anchors.*

• Screw in mounting screws to the marked studs and or wall anchors,

leaving roughly a 1/4" gap. This gap will be used to hang the hood in

STEP 3.

*Range hood needs to be installed in secure studs or supports. Wall anchors can be used for

additional support and will vary depending on wall material and the weight of the range hood

being installed.