Installation Guide

UNDER CABINET HOOD INSTALLATION

STEP 2

Hang & Secure the Range Hood and Connect:

• Carefully hang the hood on the mounting screws in place from STEP

1. Tighten the mounting screws to secure the hood. The bottom of the

hood should match up with the the horizontal line marked on the wall.

• Using the knockouts in the top of the hood, screw the top of the

hood in to the bottom of the cabinet above

• Drill holes in the back of the hood lining up with the wall studs that

have been previously marked,*(If the knockouts in the back of the hood

do not match up).

• Secure the hood to the wall studs using the screws included in the

hardware bag. Additionally, you may use the knockouts in the back of

the hood to add more screws

• Attach the previously installed ductwork to the hood’s blowers,

taping it in place using aluminum or HVAC tape.

• Power the hood by connecting the three pronged plug to a nearby

electrical outlet or by hardwiring the hood to a power source**.

* Use an appropriate drill bit for the mounting screws included in the hardware bag.

**Always consult an electrician before directly wiring a hood to a power source.