Installation Guide

WALL HOOD INSTALLATION

STEP 2

Install Ceiling Chimney Bracket:

• Place the chimney bracket against the ceiling, matching the center

point of the bracket with the center line of the installation area.

• Mark the locations of the bracket holes on the wall and drill the holes

where the locations are marked*.

• Insert wall anchors in the drilled holes and screw the bracket into

place. The chimney will mount to the bracket.

* The size of drill bit will depend on the size of hole that the wall anchor calls for.

STEP 3

Hang Range Hood and Connect:

• Carefully hang the hood on the mounting screws in place from STEP

1. Tighten the mounting screws to secure the hood. The bottom of the

hood should match up with the the horizontal line marked on the wall.

• Drill holes in the back of the hood lining up with the wall studs that

have been previously marked**.

• Secure the hood to the wall studs using the screws included in the

hardware bag.

• Attach the previously installed ductwork to the hood’s blowers,

taping it in place using duct tape or HVAC tape.

• Power the hood by connecting the three pronged plug to a nearby

electrical outlet or by hardwiring the hood to a power source***.

** Use an appropriate drill bit for the mounting screws included in the hardware bag.

***Always consult an electrician before directly wiring a hood to a power source.