User manual
7
COSMIC 1500DMX/COSMIC 1500
- 3 - FUNCTIONS AND SETTINGS
3.1 OPERATION
Connect the supplied main cable to a socket ((230V~/50Hz). Then the unit is ready for operation and can
be operated via a DMX controller or in manual mode. To switch o, disconnect the mains plug from the
socket. For a more convenient operation it is recommended to connect the unit to a socket which can be
switched on and o via a light switch.
3.2 SETTING OF DIP-SWITCH
The COSMIC has a basic control panel consists of a DIP-switch (g.5)
Each individual switch has a number (DIP-switch [1] to [10]).
3.3 MANUAL MODE
To set the manual mode is necessary to position the DIP-switch [10] to “ON”. Use the potentiometers to
adjust ashing speed and brightness.
3.4 DMX OPERATION
To set the DMX mode is necessary to position the DIP-switch [10] to “OFF”.
Through DIP-switch [1 - 9] you can select dierent DMX addresss.
The table indicate the operating mode and DMX value. The COSMIC is equipped with 3 -pole XLR connec-
tions.
Fig.5
CH Function in CH2 mode Value
1
SPEED
0% - 100% 000 - 255
2
DIMMER
0% - 100% 000 - 255
NOTE - This mode will allow you to link up the units together with a controller. Use standard DMX cables
to daisy chain your units together via the DMX connector on the rear of the units. For longer cable runs we
suggest a terminator at the last xture (see page 9).