User manual

COSMIC 1500DMX/COSMIC 1500

- 2 - INSTALLATION

2.1 MOUNTING

The COSMIC1500DMX/COSMIC1500 can be xed (as shown below) using the mounting bracket screws

or using the dedicated lighting support if mounted on a crossbeam. The mounting place must be of suf-

cient stability and be able to support a weight of 10 times of the unit’s weight.

When carrying out any installation, always comply scrupulously with all the regulations (particularly re-

garding safety) currently in force in the country in which the xture’s being used.

• Install the projector at a suitable location by means of the mounting bracket.

• Always additionally secure the projector with the safety rope from falling down. For this purpose, fas-

ten the safety rope at a suitable position so that the maximum fall of the projector will be 20 cm.

• Adjust the projector and use the knob to slightly release or tighten the locking mechanism of the

bracket if is necessary.

Fig.3

Fig.4

2.2 INSERTING OR REPLACING THE LAMP

1. Loosen the screws (A) as shown and open the glass cover.

2. Loosen the screws (B) & (C).

3. Remove the old lamp and replace it with the new. Connect the wire of the lamp. Make sure the lamp

wires are tucked neatly inside the unit.

4. Close the glass cover and tighten the screws.

5. Tighten the screws to close the rear lid..

Pannello posteriore