User`s manual

PT-1441 User’s Manual
www.prokits.com.tw 5
Product Features
Initial operation
Insertion and Removal of Rechargeable Battery
Ensuring the correct orientation between the battery and the battery compartment, insert the rechargeable
battery into the machine. Do not apply force when inserting the battery. Insertion can be achieved easily and
without resistance. The battery must be inserted completely until the battery retention clips on the sides of the
battery compartment automatically lock it into place. To remove the battery press the battery retention clips and
pulls the battery out of its compartment.
Charging the Battery
The rechargeable battery must be charged before the first use. Only recharge the battery once it is has been
fully discharged, i.e. the performance clearly decreases. Otherwise the battery may not achieve its full capacity
at the subsequent charge.
Important! Only use the provided battery charger for charging the battery. First place the rechargeable battery
into the charging slot in the charger and then connect the charger to the mains. Charging starts automatically.
Remove the battery from the charge after about 5 hours. Always disconnect the charger from the mains before
you remove the battery from the charger.
Inserting Tool Bits
Important! Always remove the battery before you change the drill or screw bit to avoid unintentional starting of
the machine.
The cordless drill has a keyless chuck so you do not need a key to lock the tool bit in place. Make sure that the
drill or screw bit is not skew when it is inserted and the chuck tightened.
Before inserting drill/screw bits open the jaws of the chuck by holding the lower ring of the chuck and turn the
locking ring anticlockwise. Open the chuck until you can insert the tool. Insert the drill/screw bit all the way in
Operating
trigger
Forward &
Reverse switch
Torque
adjustment
Battery
Charger
Battery
Release Button