User`s manual

Fitting Tools and Operation
Observe safety notes.
Ensure t
ool is switched off and
disconnected from the power supply.
Fit a tool
1. Hold the tool firmly, press the spindle lock,
loosen the locking collar.
2. Remove previous accessory and store
safely.
3. Select the appropriate accessory for the job.
4. Seat the accessory fully into the collet and
tighten the locking collar firmly.
The supplied collet can hold a tool spindle up
to 3.2mm. To change the collet, completely
remove the locking collar, the collet can then
be freely replaced and then secured with the
same locking collar.
Operation
After fitting the tool, ensure the switch is in the
off position and connect the PT-5202 mini
grinder to the supplied power adaptor.
Starting work
1. Mark the work to be done, the supplied
stencils can assist with this (they are not
designed to be used with the tools directly).
2. Use a mask or guide to prevent damage to
surrounding areas.
3. Hold the grinder firmly and switch on, test
the tool against the surface to check action
before beginning work.
4. Complete the work in stages, do not apply
excess pressure or cause the tool to slow
down.
8