Instruction Manual

CAUTION

• Do not rotate the blade with hands.

Do not rotate the blade with metallic tweeze

Doing so

• rs.

may damage the blade.

3. ig

4. Tr the fiber. Perform a visual check of the

LADE HEIGHT ADJUSTMENT

T hten the blade set screw.

y and cleave

fiber end face with splicer. If the fiber end face is poor

just the blade height. (Refer to “Blade height

justment)

ttached hex key.

er, if not good

1. Loosen the 2 Hex Screws with the a

(Fig3)

2. Turn the blade height adjustment slot screw (Fig4)

3. Tighten the 2 Hex Screws with the attached hex key

(Fig5).

4. Cut fiber to test the performance of cleav

quality, adjust the blade again until optimized.

Fig 3 Fig4 Fig5