User`s guide

english
14Multi image processor User’s Guide – Installation and setup
4.6 Firewall settings
The multi image processing system processor communicates extensively on the network. In
order for it to communicate freely with the ProNet application, the following ports must be
open in the firewall:
• 22 outbound (SSH)
• 1900 inbound (UPnP open for AutoDiscovery of multi image processing system
processors)
• 30000 outbound (dedicated multi image processing instruction command set)
• 40400 outbound (dedicated ASCII command set)
• 49500 - 49600 inbound (configurational range; one port number per multi image unit)
Note! The firewall must not filter Ping on LAN (ICMP Type 8 (ICMP Echo Request)).
4.7 Software
To the use multi image processing system, ProNet.site must be installed on a control PC.
The latest version of the software can be found at www.projectiondesign.com
A license key is required to use the software. The key can be acquired by contacting an
authorised projectiondesign representative.
4.8 Mounting the multi image processing system processor in rack
Each multi image processing system processor is half-width, 1U standard size, so two
channels can be combined in a single standard 19” 1RU rack mounting plate, available from
projectiondesign. Remove the upper and lower screws on each side of the multi image pro-
cessing system processor, position the mounting plate and reenter the screws as shown in
Figure 4-4 and Figure 4-5.
Figure 4-4. Rack mount plate
Figure 4-5. Rack mounted